AMIKON LIMITED
We'll get back to you as soon as possible.
Place of Origin:
Germany
Brand Name:
Siemens
A PS 405 power supply module for S7-400 automation racks, accepting a DC input network and providing the 5 V and 24 V supply rails used by the system.
This order number identifies the standard PS 405 10A version. It converts the incoming DC supply into the secondary voltages required by the S7-400 rack. The 5 V rail supplies the backplane bus, while the 24 V rail provides an additional rack supply.
Electrical ratings, construction and operating conditions
Maximum inrush current: 18 A peak
Inrush current half-value width: 20 ms
Optional backup battery: 2 × lithium AA
Battery specification: 3.6 V / 2.2 Ah
Backup current when power is off: 100 µA maximum
Electrical connection: 3 × 1.5 mm²
Conductor: Solid or stranded wire with end sleeve
Cable external diameter: 3–9 mm
Equipment protection class: Class I, with protective conductor
Overvoltage category: II
Pollution degree: 2
Common maintenance situations that may lead engineers to identify this part number
Searched when an S7-400 rack loses its supply or the expected DC rails are unavailable.
Relevant when front-panel indicators show an internal fault or abnormal 5 V / 24 V output status.
May be considered when connected loads cause an output to drop or the power supply to shut down.
Relevant when battery monitoring indicators report a fault and maintenance is required.
A failed rack power supply can interrupt the DC rails required by the S7-400 system. Depending on the control architecture and process, the resulting controller outage may stop equipment or production until the power fault is resolved.
The module provides status indicators and service controls to support fault identification.
Interpret LED combinations using the Siemens S7-400 diagnostic instructions. Check the incoming DC supply and connected loads during fault isolation. The standby switch does not isolate the module from its external supply.
S7-400 power supply modules are permitted in designated rack positions. The manual identifies slots 1 to 4 and specifies consecutive installation from slot 1 without gaps.
Use the specified three-conductor connection. Siemens documents 1.5 mm² solid or stranded wire with an end sleeve and a cable external diameter of 3–9 mm.
The standby switch does not disconnect the module from its external supply. Isolate the supply system before removing or installing the module. Follow the applicable S7-400 installation instructions and qualified-personnel requirements.
AMIKON assists maintenance, engineering and purchasing teams with industrial automation component sourcing. Send us the part number and application details for quotation review, availability confirmation and order coordination.
A few order details help us review the request accurately.
Inspection and testing according to the agreed quotation and available test scope.
Protective packaging for shipment and handling.
Report issues promptly with order details and supporting evidence. Handling follows agreed order terms.
12-month warranty, subject to the terms stated in the quotation.
A. It is a PS 405 10A power supply module for the Siemens SIMATIC S7-400 automation system.
A. The rated input values are 24 V, 48 V and 60 V DC. The documented static input range is 19.2–72 V DC.
A. Check the external DC supply, module position, front-panel status indicators and connected loads. Use Siemens diagnostic instructions to identify the fault condition.
A. Yes. Siemens specifies two optional lithium AA backup batteries for this module.
A. No. This is the standard PS 405 10A version. Siemens identifies a separate PS 405 10A R order number for redundant operation. Confirm the rack design and required order number before selecting a replacement.
Additional part-number references only. Listing does not imply compatibility or interchangeability with this product.
For model-specific verification, refer to the Siemens 6ES7405-0KA02-0AA0 datasheet and the S7-400 Automation System Module Data reference manual, section 3.15.
Send your inquiry directly to us