Approximate sensing range: The nominal linear range spans approximately 0.25–2.3 mm (10–90 mils) from the target. The output voltage changes with the distance between the probe tip and the conductive target.

Recommended radial vibration gap: −9 Vdc, corresponding to approximately 1.27 mm (50 mils), for the specified complete system.

Scale factor tolerance: The standard 1 m or 5 m system specifies 7.87 V/mm (200 mV/mil) ±5%, including interchangeability error, when measured in 0.25 mm increments over the linear range from 0°C to +45°C.

Linearity conditions: The specified straight-line deviation applies to standard 1 m or 5 m systems with components at 0°C to +45°C. Temperature-related performance limits depend on the temperatures of the probe, extension cable and Proximitor sensor.

Proximitor sensor supply: The associated sensor requires −17.5 to −26 Vdc for the specified non-incendive installation, with maximum consumption of 12 mA. With barriers, the stated range is −23 to −26 Vdc. A supply more positive than −23.5 Vdc can reduce the linear range. These are sensor requirements, not probe-only ratings.

Sensor output characteristics: The Proximitor sensor output resistance is 50 Ω. Supply sensitivity is less than 2 mV of output change per volt of input-supply change.

Field wiring: Use 0.2–1.5 mm² (16–24 AWG) wiring; a three-conductor shielded triad is recommended. The maximum specified distance between the Proximitor sensor and monitor is 305 m (1,000 ft). Actual wiring can affect high-frequency response.

Extension cable: Where the system requires an extension cable, its typical capacitance is 69.9 pF/m and the minimum bend radius is 25.4 mm (1.0 in). The probe length and extension cable length must match the selected Proximitor system length.

Mounting torque: For a standard forward-mounted probe configuration, the recommended case torque is 11.2 N·m (100 in·lbf), with a maximum of 33.9 N·m (300 in·lbf). For the first three threads, the recommended value is 7.5 N·m (66 in·lbf), with a maximum of 22.6 N·m (200 in·lbf). Confirm the mounting arrangement before applying torque.

System components: A complete transducer system uses a compatible probe, Proximitor sensor and, where required, extension cable. A 1 m system uses the probe without a separate extension cable. System length and component compatibility must be maintained.

Target material: The standard performance specifications use AISI 4140 steel as the target material. Other target materials can affect the scale factor and measurement accuracy.

Documentation lookup: For a 330103-00-11-10-02-05 datasheet check, verify the complete ordering code and approval selection against current manufacturer documentation.