The probe tip is made from polyphenylene sulfide (PPS). The probe case uses AISI 303 or 304 stainless steel. The standard probe cable is 75 Ω triaxial cable with FEP insulation.

The published reverse-mount drawing identifies a 5.0 mm (0.20 in) unthreaded length, a 30 mm (1.2 in) case length, and a maximum 6.0 mm (0.235 in) dimension at the indicated feature. Refer to the dimensional drawing for the exact measurement points.

The standard probe cable has a maximum outside diameter of 3.68 mm (0.145 in). The miniature male coaxial connector has a maximum outside diameter of 7.24 mm (0.285 in). ClickLoc connectors use a locking mechanism and are designed for finger-tight connection.

For reverse-mount probes, the published recommended case torque is 7.5 N·m (66 in·lbf), with a maximum rated torque of 22.6 N·m (200 in·lbf). The minimum cable bend radius is 25.4 mm (1.0 in). Follow the applicable installation instructions and do not exceed the specified limits.

The 1.0 m option is the probe's integral cable length; a one-meter system does not use a separate extension cable. For systems with an extension cable, the probe length and extension cable length must add up to the Proximitor Sensor's specified system length.

For a standard 1 m or 5 m 3300 XL 8 mm system, the published incremental scale factor is 7.87 V/mm (200 mV/mil) ±5%, including interchangeability error under the specified test conditions. The nominal linear range is 2 mm (80 mils), approximately 0.25–2.3 mm (10–90 mils) from target. These are system-level values, not independent probe-only specifications.

The standard 1 m and 5 m system performance specifications include a probe temperature range of −35°C to +120°C, with the Proximitor Sensor and any extension cable between 0°C and +45°C for the stated extended-performance conditions. Do not treat these system conditions as a standalone temperature rating for every individual component.

The manufacturer describes electrical and physical interchangeability between 3300 XL 8 mm components and non-XL 3300-series 5 mm and 8 mm components, subject to the stated system-performance limitations. Mixing XL and non-XL components limits performance to the applicable non-XL system specifications.

The official ordering table lists the 330105 reverse-mount family with 3/8-24 UNF threads, length option 10 for 1.0 m, and connector option 02 for the miniature ClickLoc coaxial connector. The published agency-approval options are 00 (not required) and 05 (CSA, ATEX, IECEx approvals). The supplied final suffix “CN” is not identified as an agency-approval option in this table. Confirm the exact suffix and any required certification against the product label and manufacturer documentation before ordering.