System-specific ABB interface electronics for established control installations where the complete material code and AE01 revision define the replacement identity.
IDENTITY STACK
ABB Manufacturer
UFB009 Board family
AE01 Revision identity
EXACT-CODE SUPPORT
Match HIEE400961R0001 and UFB009AE01 together Sales Manager: Miya Zheng
A controlled signal bridge inside the installed system
⌁
Control side Installed logic path
→
▦
UFB009AE01 Interface stage
→
◎
System side Matched endpoints
Replacement success depends on the complete board code, connector arrangement, paired electronics and the installed system revision—not the UFB009 name alone.
02 / REPLACEMENT MAP
Four identities that must remain aligned
01
Material code
HIEE400961R0001 is the primary hardware identity; shortened variants must not be assumed equivalent.
02
Board revision
AE01 remains part of the identity and can affect connector, circuit and paired-board compatibility.
03
Installed slot
Use the same intended rack position and preserve the original connector orientation and cable routing.
04
Peer electronics
The mating board set and application state determine whether a replacement can operate as expected.
AMIKON · SINCE 2005
Industrial automation support for planned and urgent requirements
Broad PLC, HMI, DCS, industrial PC and drive coverage with responsive service, warranty support and urgent dispatch options.
20+ years
Global reach
Responsive service
03 / BUYER FAQ
Compatibility questions worth resolving
?
Q
Is ABB HIEE400961R0001 UFB009AE01 interchangeable with HIEE400961R1?
A
No automatic equivalence should be assumed. R0001 and R1 are different material-code forms; the board build and installed interface arrangement must match the original position.
Q
Can ABB HIEE400961R0001 UFB009AE01 be selected by the UFB009 name alone?
A
No. The complete HIEE code and AE01 revision carry the hardware identity needed to avoid a visually similar but electrically different board.
Q
What should remain paired when ABB HIEE400961R0001 UFB009AE01 is replaced?
A
Preserve the original slot, mating connectors, cable destinations, paired electronics and the active application state. A board-only swap cannot correct a mismatched peer assembly.
Q
Can ABB HIEE400961R0001 UFB009AE01 be bench-powered as a stand-alone board?
A
Treat it as a system board, not a stand-alone device. Applying power without the exact rack pinout and intended load path can damage the board or produce misleading results.
Q
Why can ABB HIEE400961R0001 UFB009AE01 pass a visual check yet fail in service?
A
A matching outline does not confirm revision, connector routing, circuit population or peer compatibility. Functional acceptance must be completed in the intended system position.